Waveshare for Raspberry Pi 6Inch Ink Screen Module E-Paper HD 1448 x1072 Resolution Black and White 16 Gray Levels

E-ink screen module, 6-inch, high-definition, with a resolution of 1448 x 1072, using IT8951 as a controller, which can be controlled using USB / SPI / I80 interface, and supports partial refresh.
Low power consumption, wide viewing angle, clear display when power is off, etc. It can be used for display applications such as shelf labels and industrial instruments.
No backlight required, keep the last screen displayed for a long time after power off
color: White
Material: electronic ink + PCB
Low power consumption, bare screen of electronic ink screen consumes power only when refreshing
Based on for Raspberry Pi 40PIN GPIO interface design, suitable for Raspberry Pi series motherboards
Lead out USB / SPI / I80 control interface, can be connected to Raspberry / Nucleo and other main control boards
Provide complete supporting information manual (example programs such as Raspberry / STM32)
Working voltage: 5V
Communication interface: USB / SPI / I80
Dimensions: 138.4mm x 101.8mm x 1.01mm
Display size: 122.4mm x 90.6mm
Dot Pitch: 0.0845mm x 0.0845mm
Resolution: 1448 x 1072
Display colors: black and white
Gray level: 2-16 levels (1-4 bits)
Global refresh: Less than 1s
Total refresh power: 0.88W (typ.)
Total standby power: 0.1W (typ.)
Viewing angle:Greater than 170 °
SPI interface
5V: 5V power input
GND: GND
MISO: SPI communication MISO pin
MOSI: SPI communication MOSI pin
SCK: SPI communication SCK pin
CS: SPI chip select pin (active low)
RST: external reset pin (low-level reset)
HRDY: busy status output pin (low level means busy)
Package Contents:
1* 6inch HD e-Paper
1* e-Paper IT8951 Driver HAT (B)
1* 6inch e-Paper Adapter (B)
1* 40PIN FFC (same direction)
1* USB cable type A male port to Micro-maleport
1* PH2.0 8PIN cable 20cm
2* RPi Copper Post Package
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.